KYMCO Mongoose/KXR 250

14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM
14-4
Mongoose/KXR 250
FRONT WHEEL HUB
REMOVAL AND INSPECTION
Place the machine on a level place.
Remove the front wheel (
Ö
14-3) and
caliper. (
Ö
13-8)
Elevate the front wheels by placing a
suitable stand under the frame.
Remove the cotter pin.
Remove nut attaching the front wheel hub
and then remove front wheel hub.
DISASSEMBLY
Remove the outside collars.
Inspect the dust seals for wear or damage.
If any defects are found, replace the dust
seal with a new one.
Remove the dust seals by a flat-head screw
driver.
Inspect the bearings for allow play in the
front wheel hub or the wheel turns roughly.
Support the machine securel
y
so
there is no danger of it falling over.
＊
Place a wood block a
g
ainst the outer
edge to protect this edge.
＊
N
uts Cotter Pin
Outside Colla
r
Dust Seal
Outside Colla
r
Dust Seal
Bearing