KYMCO Mongoose/KXR 250

2. FRAME COVERS/EXHAUST MUFFLER
2-7
Mongoose/KXR 250
EXHAUST MUFFLER
REMOVAL
Remove the two exhaust pipe joint lock
nuts.
Remove the bolt at the exhaust muffler,
disconnect the exhaust pipe from the
exhaust muffler.
Inspect the gasket.
If the exhaust gas leaks, the gasket should
be replaced.
Install by reversing the removal sequence.
Torque:
Exhaust muffler lock bolt: 3.2～3.8kgf-m
Exhaust muffler lock nut: 1.8～2.2kgf-m
Remove the nut and bolt at the exhaust
muffler, then remove the exhaust muffler.
INSTALLATION
Install by reversing the removal sequence.
Torque:
Exhaust muffler lock bolt and nut:
3.2～3.8kgf-m
N
uts
Bol
t
Gaske
t
N
u
t
Bol
t
Be sure to install a new exhaust gasket.
＊