KYMCO Mongoose/KXR 250 User Manual

13. BRAKE SYSTEM
13-11
Mongoose/KXR 250
REAR HYDRAULIC BRAKE
REAR BRAKE PADS REMOVAL
Remove the brake pads cover.
Remove the cotter pin and then pull out the
brake pad pin from the caliper.
Remove the brake spring plate and then
remove brake pads.
INSTALLATION
Reverse the “REAR BRAKE PADS
REMOVAL” procedures.
BRAKE FLUID DRAINING
Place the machine on the level ground.
Remove the two screws attaching the brake
fluid reservoir cap (brake lever and brake
pedal).
Use shop towels to cover plastic parts
and coated surfaces to avoid damage
caused by splash of brake fluid.
＊
• Make sure put the spring plate big end
on the rear caliper.
• Make sure put the spring plate small
end on the rear pads.
• Make sure brake pad pin over the
spring plate.
＊
Brake Pad Cove
r
Cotter Pin
Brake Pad Pin
Spring Plate
Brake Pads
Spring Plate Big End
Spring Plate Small End
Brake Pad Pin
Reservoir (Front Left Lever)
Reservoir Cover (Pedal)

KYMCO Mongoose/KXR 250 Specifications

General

Brand	KYMCO
Model	Mongoose/KXR 250
Category	Offroad Vehicle
Language	English