KYMCO Mongoose/KXR 250 User Manual

13. BRAKE SYSTEM
13-10
Mongoose/KXR 250
Install the caliper spring plate into the
caliper.
INSTALLATION
Reverse the “FRONT BRAKE CALIPER
REMOVAL” procedures.
Connect the brake fluid tube to the brake
caliper and tighten the fluid tube bolt.
Torque: 1.8～2.5kgf-m
Fill the brake reservoir with the specified
brake fluid and bleed air from the brake
system. (
Ö
13-4)
Make sure that the boss on the calipe
r
correctly engages with the locating slot
on the caliper spring plate.
＊
When installing the brake caliper, be
sure to position the brake disk between
the two brake pads.
＊
When installing the brake fluid tube, be
sure to install the two sealing washers.
＊

KYMCO Mongoose/KXR 250 Specifications

General

Brand	KYMCO
Model	Mongoose/KXR 250
Category	Offroad Vehicle
Language	English