KYMCO Mongoose/KXR 250 User Manual

13. BRAKE SYSTEM
13-9
Mongoose/KXR 250
Push the piston oil seal outward to remove
it.
Clean the seals groove with brake fluid.
INSPECTION
Inspect the caliper cylinder wall and piston
surface for scratch, corrosion or other
damages.
If any abnormal condition is noted, replace
the caliper.
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the piston and oil
seals. Lubricate the brake caliper cylinder
inside wall with brake fluid.
Install the oil seal and dust seal.
Install the brake caliper piston with grooved
side facing out.
Wipe off excessive brake fluid with a clean
shop towel.
Be careful not to damage the piston
surface.
＊
Install the piston with its outer en
d
protruding 3～5mm beyond the brake
caliper.
＊
Inner Oil Seal

KYMCO Mongoose/KXR 250 Specifications

General

Brand	KYMCO
Model	Mongoose/KXR 250
Category	Offroad Vehicle
Language	English