KYMCO Mongoose/KXR 250

14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM
14-3
Mongoose/KXR 250
FRONT WHEEL
REMOVAL AND INSPECTION
Place the machine on a level place.
Remove four nuts attaching the front wheel
hub and front wheel.
Elevate the front wheels by placing a
suitable stand under the frame.
Measure the wheel run out.
Replace wheel or check bearing play if out
of specification
Rim run out limits:
Vertical: 2.0mm
Lateral: 2.0mm
INSTALLATION
When reinstalling a wheel, tighten the
wheel nuts in a crisscross (rather than a
circular) pattern.
Torque: 4.0～5.0kgf-m
Support the machine securel
y
so
there is no danger of it falling over.
＊
Be sure the tapered side of the wheel
nuts face the wheel rim.
＊
N
uts