Kyocera ECOSYS FS-1135MFP User Manual

10-12
Troubleshooting
Responding to the flashing Attention LED
If the Attention LED flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on
the Message Display when [Status/Job Cancel] is pressed or the Attention LED flashes for 1.5 seconds, check the
following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax. Is the modular cord
connected correctly?
Connect the modular cord
correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX No.
and Permitted ID No..
FAX Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report and
Activity Report. If the error
code starts with "U" or
"E", perform the
corresponding procedure.
FAX Operation Guide
Appendix
"Error Code List"
Is the destination FAX line
busy?
Send again. —
Does the destination FAX
machine respond?
Send again. —
Is there an error other
than above?
Contact your Service
Representative.
—

Kyocera ECOSYS FS-1135MFP Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Standard Memory	256 MB
Connectivity	USB 2.0, Ethernet
Scanner Type	Flatbed, ADF
Scan Resolution	600 x 600 dpi
Copier Resolution	600 x 600 dpi
Fax Capability	Yes
Fax Transmission Speed	33.6 kbps
Maximum Paper Size	A4
Operating System Compatibility	Windows, Mac OS, Linux
Dimensions	494 x 430 x 448 mm
Print Speed	35 ppm
Standard Input Capacity	250 sheets
Copy Speed	Up to 35 cpm
Maximum Input Capacity	800 sheets (with optional paper feeders)