FAX Operation (Basic)
3-2
Automatic Send
General transmission using the numeric keys is explained.
Switching to the Send Screen
1 Press the FAX key. Check that the basic send screen is
displayed.
NOTE: Depending on the settings, the Address Book
screen may appear. In this event, press Reset to display the
basic screen for sending.
In addition to fax, you can include e-mail transmission and/or
folder (SMB/FTP) transmission in a single transmission job
(Multi Sending). Press the Send key to select the
destinations. For details, refer to Sending in the Operation
Guide for the machine.
Selection of Transmission Method
2 There are two transmission methods - memory
transmission and direct transmission. The default is
memory transmission.
To select direct transmission, use the following
procedure.
1 Press the Function Menu key.
2 Press the or key to select [FAX Direct TX].
3 Press the OK key.
4 Press the or key to select [On].
5 Press the OK key.
NOTE: In direct transmission, you can designate only one
destination for one transmission.
Setting for Direct
transmission
Description
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
On Starts direct transmission.
Dials the receiving system, and after the communication has
started, originals are scanned.
To Next Page
Loading...
