Kyocera ECOSYS PA4500cx - Page 224

System Menu > Network
217
[EnhancedWSD(TLS)]
[VNC(RFB)overTLS]
[VNC (RFB)]
Item Description
[Off/On]
Set whether to use our proprietary Web service on TLS.
*1
The setting will be changed after restarting the device or network.
Value: [Off], [On]
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Off/On] Set when using a remote operation protected by TLS by starting up a
VNC Viewer other than ours (example: Real VNC). The default port
number is 9063.
*1
The setting will be changed after restarting the device or network.
Value: [Off], [On], 1 to 32767 (Port Number)
NOTE
If the setting is [On], a TLS certificate is required. The factory certificate is
the certificate owned by the machine.
➡ Command Center RX User Guide
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Off/On] Set when using a remote operation by starting up a VNC Viewer other
than ours (example: Real VNC). The default port number is 9062.
The setting will be changed after restarting the device or network.
Value: [Off], [On], 1 to 32767 (Port Number)
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]