System Menu > Network
218
[EnhncdVNC ov TLS]
*1 In [Security] set [TLS Setting] to [On].
➡ [TLS Setting] (page 237)
IMPORTANT
Depending on the protocol, it may be necessary to restart the network or turn the power off/on after changing
the settings.
Item Description
[Off/On] Start Command Center RX and set for using TLS-protected remote
operation. The default port number is 9061.
*1
The setting will be changed after restarting the device or network.
Value: [Off], [On], 1 to 32767 (Port Number)
NOTE
• The factory default setting is [On].
• If the setting is [On], a TLS certificate is required. The factory certificate
is the certificate owned by the machine.
➡ Command Center RX User Guide
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
To Next Page
Loading...
