Using the Operation Panel
ADVANCED OPERATION GUIDE 2-41
8
Press [OK].
9
Press [Menu]. The display returns to Ready.
Changing the Default Font Size
You can change the size of the default font. If you selected a proportional
font, the character size can also be changed.
1
Press [Menu].
2
Press ? or @ repeatedly until Font >
appears.
3
Press B. Press ? or @ until >Font
Select > appears.
4
Make sure that Internal is displayed and press Z.
5
Press ? or @ repeatedly until >>Size
appears.
6
Press [OK]. A blinking cursor (_) appears.
7
Press ? or @ to increase or decrease the value at the blinking cursor. The
font size can be set between 4 and 999.75 points, in 0.25-point increments.
Use B or A to move the cursor right and left.
8
When the desired size is displayed, press [OK].
9
Press [Menu]. The display returns to Ready.
Font >
>Font Select >
Internal
>>Size
012.00 point(s)
>>Size
012.00
point(s)
To Next Page
Loading...
