Using the Operation Panel
2-42 ADVANCED OPERATION GUIDE
Character Pitch for Courier/Letter Gothic
You can set the character pitch for fixed fonts when the default font is
Courier or Letter Gothic.
1
Press [Menu].
2
Press ? or @ repeatedly until Font >
appears.
3
Press B. Press ? or @ until >Font
Select > appears.
4
Make sure that Internal is displayed and press Z.
5
Press ? or @ repeatedly until >>Pitch
appears.
6
Press [OK]. A blinking cursor (_) appears.
7
Press ? or @ to increase or decrease the value at the blinking cursor. The
character pitch can be set between 0.44 and 99.99 characters per inch, in
0.01 character-per-inch increments. Use B or A to move the cursor right and
left.
8
When the desired size is displayed, press [OK].
9
Press [Menu]. The display returns to Ready.
Setting the Code Set
You can change the character code set. Available character code sets vary
depending on the current font. (The default is IBM PC-8.)
1
Press [Menu].
2
Press ? or @ repeatedly until Font >
appears.
3
Press B.
Font >
>Font Select >
Internal
>>Pitch
10.00 cpi
>>Pitch
10.00
cpi
Font >
To Next Page
Loading...
