Kyocera KM-1650 User Manual

i
Sending Scanned Image Data to Your Computer (Scan to PC)
Create a destination folder in your computer and you can have scanned image data sent directly to that
folder. The flowchart below shows a simple illustration of the steps required up to transmission of the data to
the computer.
For a more detailed explanation of each step, refer to the indicated reference page.
Click on the reference page will take you directly to that page.
Making basic settings
Creating destination folders
Sending scanned image data
Use the scanner to designate a destination and
have scanned image data sent directly to that
location.
See page
3-28
Settings and registra-
tion using Address
Editor
See page
3-73
Settings and registra-
tion using Address
Book
See page
2-1
Settings and registra-
tion using an Internet
Web browser
In order to use the Scan to PC function it is necessary to utilize the included utilities and make network
settings and register such information as the sender and destination addresses.
See page
3-4
Scanner File Utility
* Network settings as well
as the sender and
destination address
registration procedures
can be accomplished at
the scanner itself. For
information on these
procedures, refer to the
<Setup Edition> of this
Operation Guide.

Kyocera KM-1650 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Resolution	600 x 600 dpi
Paper Capacity	300 sheets
Memory	32 MB
Functions	Print, Copy, Scan
Type	Monochrome
Grayscale Half-Tones	256 levels
Max Document Enlargement	200%
Max Document Reduction	50%
Output Trays Capacity	250 sheets
Monthly Duty Cycle	15, 000 pages
Scan Type	Flatbed
First Copy Out Time B/W	5.9 seconds
Supported Media Type	Plain paper
Max Media Capacity	1, 300 sheets
Interface	USB 2.0
Original Size	A3 (11.7 in x 16.5 in) (max)