Kyocera KM-1650

Page 2-13
System Setting
• Subnet Mask
Register the subnet mask of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX
• Default Gateway
Register the default gateway of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX
• DHCP/BOOTP
The DHCP and BOOTP can be set to either “ENABLE” or “DISABLE”. The factory default setting is
“ENABLE”.
• RARP
The RARP can be set to either “ENABLE” or “DISABLE”. The factory default setting is “ENABLE”.
• ARP/PING
The ARP/PING can be set to either “ENABLE” or “DISABLE”. The factory default setting is “ENABLE”.
[Set up] - [Network]
• Host Name
Register the host name of the scanner (up to 32 single-byte characters) in this field.
• IP Address
Register the IP address of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX