3NY
1-2-1
1-2 Installatio n
1-2-1 Unpacking and installation
(1) Installation procedure
1. Remove the paper feeder from the con-
tainer box and place the feeder where
you want to install it.
2. Lift the printer up without tilting it, then
put it down onto the paper feeder(s) by
fitting the four corners as shown in the
figure.
(The number of the maximum stages:
Four steps)
Figure 1-2-1
1. Pull the cassette from the paper feeder
out while griping the release lever.
Figure 1-2-2
Installing the paper feeder
Loading paper into the cassette
Release lever
Paper feeder
Cassette
To Next Page
Loading...
Need help?
General