2K5
1-5-41
(3) Detaching and refitting the press roller
Follow the procedure below to replace the press roller.
Procedure
1. Remove the fuser unit (see page 1-5-37).
2. Unhook four hooks and remove the fuser
unit cover.
3. Remove two connectors.
Figure 1-5-76
4. Remove four screws.
5. Separate the right fuser frame and left fuser
frame.
Figure 1-5-77
Fuser unit cover
Connector
Connector
Hook
Hook
Hook
Hook
Screw
Screw
Right fuser frame
Left fuser frame
Screw
Screw
To Next Page
Loading...
