Copying Functions
4-14 OPERATION GUIDE
Types of Page Boundary Lines
The following types of the boundary lines are available.
The procedure for using Combine mode copying is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Layout/Edit] and then [Combine].
4 Press [2 in 1] or [4 in 1], and choose the page layout
of Layout.
5 Press [Border Line] to choose the type of the lines
to indicate page boundaries. Press [OK].
6 Press [Original Orientation] to choose orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
7 Press [OK].
8 Press the Start key. Copying begins.
If the original is placed on the platen, replace the
original and press the Start key.
After scanning all originals, press [Finish Scan] to
start copying.
To Next Page
Loading...
