Kyocera TASKalfa 420i - Color; Grayscale; Black and White Selection

Sending Functions
OPERATION GUIDE 5-21
5
Color / Grayscale / Black and White Selection
This feature allows you to select the color mode used for scanning when sending images. You can select from
Auto (Color/Gray), Auto (Color/B & W), Full Color, Grayscale or Black & White.
Use the procedure below to select the color mode when sending scanned images.
1 Press the Send key.
2 Place the originals on the platen.
3 Press [Color/Image Quality] and then [Color
Selection].
4 Select the color mode to be used for scanning.
5 Press [OK].
6 Specify the destination, and press the Start key to
start sending.
Black & WhiteGrayscale
Color Selection
Full Color
Select scanning color.
Select [Auto Color] to automatically send color originals
in full color and black & white originals in black & white.
Cancel OKAdd Shortcut
Status
08/08/2009 10:10
Preview
Original
Zoom
Paper
100%
---
:
:
:
---
Place original.
Place original.
Ready to send.
Destination
Auto Color
(Color/B & W)
Auto Color
(Color/Gray)