Basic Operation
OPERATION GUIDE 3-7
3
Adjusting Density
Use this procedure to adjust the density when copying.
NOTE: You may choose Auto mode as the default setting (refer to Density on page 8-18).
The procedure for adjusting the density of copies is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Set the original on the platen and press [Image
Quality] -> [Density].
4 Adjust density manually pressing [-3] (Lighter) to
[+3] (Darker). You can change the density level [-3]
(Lighter) to [+3] (Darker) in half-steps.
To change density adjustment from Manual to Auto,
press [Auto].
5 Press [OK].
6 Press the Start key. Copying begins.
Density Adjustment Option Description
Manual Adjust density using 7 or 13 levels.
Auto Optimum density is selected according
to the density of the original.
To Next Page
Loading...
