Default Setting (System Menu)
OPERATION GUIDE 8-15
8
Orientation Confirmation
Select whether to display a screen for selecting the orientation of the originals to be placed on the platen when
using the following functions. (For more information, refer to page 4-10 for Original Orientation.)
Orientation Confirmation Setting
Use the procedure below to select the default Orientation Confirmation setting.
1 Press the System Menu key.
2 Press [Common Settings] and [Change] of Orientation Confirmation.
3 Select the default for [Off] or [On].
4 Press [OK].
Function Defaults
Defaults are the values automatically set after the warm-up is completed or the Reset key is pressed.
Set the defaults for available settings such as copying and sending. Setting the frequently-used values as
defaults makes subsequent jobs easier.
IMPORTANT: When you have changed the defaults, to enable the change immediately, move to the copy, send,
or document box screen and press the Reset key.
Original Orientation
Set the original orientation defaults. The available default settings are shown below.
Refer to page 4-10 for Original Orientation.
Use the procedure below to select the default orientation when originals are placed on the platen.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Original Orientation.
3 Select [Top Edge Top] or [Top Edge Left] for the default.
4 Press [OK].
• Duplex • Memo mode
• Margin/Centering originals • Page numbering
• Border erase • Booklets
• Combine mode • Staple/Punch (optional feature)
Item Description
Top Edge Top Select the original's top edge at the top.
Top Edge Left Select the original's top edge at the left.
To Next Page
Loading...
