Copying Functions
4-12 OPERATION GUIDE
Output Destination
You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE: Optional output destinations include the job separator, built-in finisher, document finisher, 3,000 sheet
document finisher, and mailbox.
The table below shows the available output destinations.
NOTE: To change default destination for copies, refer to Paper Output on page 8-14 for details.
Use the procedure below to select the output destination.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Org./Paper/Finishing] and then [Paper
Output].
4 Select the output destination for finished copies.
When you select [Finisher Tray], [Tray B], [Tray C]
or [Tray 1] to [Tray 7], select the orientation of
output copy, Face Up (print facing up) or Face
Down (print facing down).
5 Press [OK].
6 Press the Start key to start copying.
Destination Description
Top tray Top tray of the machine (where copies are stored)
Finisher Tray*
* Copy output orientation can be selected either as face-up (print facing up) or face-
down (print facing down).
Tray of the optional built-in finisher or document finisher
Tray A, Tray B*, Tray C* Trays A to C in the optional 3,000 sheet document finisher
Job Separator Tray Optional job separator
Tray 1 to 7* Trays 1 to 7 in the optional mailbox (tray 1 is the top tray)
To Next Page
Loading...
