Default Setting (System Menu)
8-16 OPERATION GUIDE
Continuous Scan
Set the continuous scan defaults. The available default settings are shown below.
Refer to page 4-10 for Original Orientation.
Use the procedure below to select the default settings for continuous scanning.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Continuous Scan.
3 Select [Off] or [On] for the default.
Use the procedure below to select the default quality setting for originals.
4 Press [OK].
Original Image
Set the default original document type. The available default settings are shown below.
Use the procedure below to select the default quality setting for originals.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Original Image.
3 Select the default original image.
4 Press [OK].
Scan Resolution
Select the default scanning resolution. The options are 600x600dpi, 400x400dpi Ultra Fine, 300x300dpi,
200x400dpi Super Fine, 200x200dpi Fine, 200x100dpi Normal.
Use the procedure below to select the default resolution setting.
Item Description
Off Continuous scan not performed
On Continuous scan performed
Item Description
Text+Photo Text and photos together.
Photo For photos taken with a camera.
Text Only text, no photos.
for OCR Image quality suitable for OCR software.*
* This function is only available for black and white mode.
Printed Document For documents printed from this machine.
To Next Page
Loading...
