.BASIC OPERATION
Scan to File or USB 17
BASIC OPERATION
4
Make sure that [MFP LOCAL] is selected and highlighted.
Proceed to Step 9.
y If [USB MEDIA] is selected, you cannot select [MFP LOCAL]. When you want to select [MFP LOCAL], press
[USB MEDIA] to cancel the selection.
y If saving data in a network folder is enabled by the administrator, you can select 2 file destinations from
[MFP LOCAL] or [USB MEDIA], [REMOTE 1] and [REMOTE 2]. If you select [MFP LOCAL], you can specify
a network folder (REMOTE 1 or 2) as a remote destination. To set a network folder as a remote destination,
proceed to Step 7.
5
To store the scan in the USB storage device, connect
the device to the equipment and wait a few seconds.
Connect the USB storage device to the USB port.
To find out the location of the USB port on the equipment, refer to
the Quick Start Guide.
USB Port
USB Storage Device
To Next Page
Loading...
