BASIC OPERATION
22 Scan to E-mail
Scan to E-mail
With this scan function, you can send your scans to a specified e-mail address as an attached file.
The Scan to E-mail function requires the network administrator to set the equipment configuration.
Scanning to e-mail
1
Place the original(s).
For help, refer to the Copying Guide.
3
Press [E-MAIL].
y If the User Authentication for Scan to E-mail setting is enabled by the administrator on COMMAND CENTER,
the AUTHENTICATION screen is displayed. In this case, proceed to Step 4.
y If the User Authentication for Scan to E-mail setting is disabled by the administrator on COMMAND CENTER,
the ADDRESS BOOK screen is displayed. In this case, proceed to Step 5.
If you want to preview your scans later, press [PREVIEW] here and then select the scan function. For
instructions on how to preview your scans, see the following section:
P.42 “Previewing Scans”
2
On the control panel, press the [SCAN] button to
enter the SCAN menu.
To Next Page
Loading...
