Kyocera TASKalfa 650c - COMMAND CENTER [Device] Tab Page

1 OVERVIEW
18 Setting up NetWare Print Server
24
Click [OK].
When it finishes initializing, the [Information] dialog box appears.
25
Click [OK].
The [Configure Novell PDS for Printer Agent] dialog box appears.
26
Select [((NONE))] in the [Printer Type] list and select [Novell Port Handler] in the [Port
Handler Type] list. Then click [OK].
The [Configure Port Handler for Printer Agent] dialog box appears.
27
Continue the procedure according to which connection type to be used.
 P.18 “Configuring the LPR connection in the TCP/IP network”
 P.19 “Configuring the queue based connection in the IPX/SPX network”
Configuring the LPR connection in the TCP/IP network
1
In the [Configure Port Handler for Printer Agent] dialog box, select [Novell LPR Printer
Gateway (SNMP)] (or [Remote (LPR on IP)]) and click [Next].
2
Enter the IP address of this equipment in the [Host Address] box, and click [Finish].
It takes about 60 seconds to load the Printer Agent. After it finishes loading the Printer Agent, the Select Printer
Drivers dialog box appears.
3
Select the printer drivers to be installed in the [Printer Drivers] list at each OS tab, and
click [Continue].
The [Information] dialog box appears.
4
Click [OK].
It takes about 60 seconds to complete the creation of the NDPS Printer object.
5
Double-click the NDPS Printer object that you created.
y The NDPS Printer dialog box appears.
6
Click [NDPS Remote Printer Management].
7
Select the [Install to workstation in this container] and click [Update driver].
8
Click [OK] to close the [NDPS Printer] dialog box.