3 About Login
This section provides information to help the administrator manage domain and
local users. The administrator can set authentication that allows the predefined
users to access the embedded server pages and set administrator passwords.
Levels of Login
An administrator can configure the device to require a user login before it is
accessed in either of three different ways of authentication described below.
If you select local or network authentication, User Login must be turned on.
The default user name and password, or the local administrator account when
User Login is turned off, is Admin.
Local Authentication
Users are registered in this device and one-to-one authentication is
performed between this printing system and a PC. A local account user
accesses the embedded server by entering User Name and Password and
selecting Local in the drop-down list (if shown) below the entries, followed by
clicking the Login button.
A user logged in with an administrator privilege can gain access to My
Information, Device Information, Job Status, Document Box, Address
Book, Settings and Links on the navigation menu.
A user logged in with a general user account cannot add or delete document
boxes, nor view the Address Book and Settings pages.
To add, delete or configure a locally authenticated user, refer to Basic >
Security > User Login on page 6-8.
Network Authentication
In the case where the device is configured for network authentication, the
device and the relevant PC's need to be under the management of a
Windows domain network. Enter User Name and Password and select the
domain you want to login in the drop-down list.
Once you have logged in with an administrator privilege, you can access to
My Information, Device Information, Job Status, Document Box,
Address Book, Settings and Links on the navigation menu.
A user logged in with a general user account cannot add or delete document
boxes, nor view the Address Book and Settings pages.
To add, delete or configure a network authenticated user, refer to Advanced
> Management > Authentication > General on page 6-42.
Authentication Using Job Account ID
In the case where the device is configured for job accounting but not for User
Login, a user can be authenticated by his/her job account ID. Enter the job
account ID in Account Login and click Login.
If a user is registered as an administrator on the User Login user list (Refer
to Basic > Security > User Login on page 6-8.), he/she can select either
Account Login or Administrator Login.
COMMAND CENTER RX
3-1
To Next Page
Loading...
