Settings Pages
Basic > Defaults > Reset
This page allows you to restart the machine in order to make all settings in the
machine valid. It is also possible to select to have all settings returned to their
factory default values.
Restart entire device
Clicking Restart restarts this machine.
Restart Network
Clicking Restart allows restarting the network interface without restarting the
machine. The network interface must be restarted whenever a change has
been made to the network settings.
Reset entire device to factory default
When clicking the Reset button, the machine returns to the factory default
settings. However, the document box, address book, user information, logs,
and certificates are not deleted.
Basic > Defaults > Device Defaults
This page allows you to change the language that is used in the display, to turn
the sleep mode on or off, etc.
Operation Panel Language
You can select the language of the messages on the display by following the
procedure given below. The following languages are available for selection
in the drop down list: English, FranƧais, Deutsch, Italiano, Nederlands,
EspaƱol, PortuguĆŖs, Russian, and the downloaded languages. You can
optionally download messages in other languages. Contact your dealer for
information. Some models may require restarting after configuration.
Sleep Timer
Specifies the time from 1 to 240 minutes after that the system enters auto
sleep mode. You can turn sleep mode on or off as follows:
1
Click Advanced on the right hand side of the Sleep Timer drop down list.
2
Turn the sleep mode On or Off.
3
Click Submit.
Override A4/Letter
Specifies whether or not the A4 and Letter size paper should be
interchangeable. When turned On, for example, if the A4 paper is not in the
tray, the Letter size paper will be selected for printing. When turned Off, the
Letter size paper will not be used in place of the A4 paper, when A4 is
selected for printing but the A4 tray is empty.
Auto Error Clear
Turns Auto Error Clear, which automatically clear errors when they occur, on
or off.
Error Clear Timer
Specifies the time between 5 and 495 seconds after which errors are cleared
automatically.
Low Power Timer
User Guide
6-6
To Next Page
Loading...
