Settings Pages
DRD Pattern
Selects the DRD pattern. This menu is available only for specific
destinations.
Remote Switching Dial Number
Specifies the remote switching dial number. You can specify it within a range
of 00 to 99. Remote switching allows you to initiate FAX reception from a
telephone connected to the FAX system.
Encryption Key No.
Sets the encryption key number to be used for encrypted communication.
F-NET
Sets the silent reception. (Available only in Japan.)
Dial-in
Activates the dial-in (direct number) call. (Available only in Japan.)
Dial-in Number
Specifies the telephone number for direct number. (Available only in Japan.)
Reception Port
Sets the receive-only port. (Available in multiport mode).
Number of Rings (Normal)
Specifies the number of rings for Auto FAX reception (Normal). You can
specify it within a range of 1 to 15.
Number of Rings (TAD)
Specifies the number of rings for Auto FAX reception (TAD). You can specify
it within a range of 1 to 15.
Number of Rings (FAX/TEL)
Specifies the number of rings for Auto FAX reception (FAX/TEL). You can
specify it within a range of 0 to 15. This is not displayed on European
models.
FAX / i-FAX > FAX > FAX Restrictions > General
The table below provides a summary of the items displayed on the FAX
Restrictions > General page.
Transmit Restriction
Selects the transmitting restriction between Off and Use Permit List +
Address Book.
Receive Restriction
Selects the receiving restriction between Off, Use Permit List + Address
Book, and Use Reject List.
Unknown Number Reception
Displayed when Use Reject List is selected in Receive Restriction. This
determines the behavior when the machine has received a FAX with an
unknown FAX number. Select Permit to permit reception of unknown
numbered faxes and select Reject to reject unknown numbered faxes.
FAX / i-FAX > FAX > FAX Restrictions > Permit Number List
The section below provides a summary of the items displayed on the Permit
Number List page.
COMMAND CENTER RX
6-25
To Next Page
Loading...
