Settings Pages
Enter the IPv4 address that receives traps. Select On to enable trap
receiving.
Trap IP Address (IPv6)
Enter the IPv6 address that receives traps. Select On to enable trap
receiving.
Trap IPX Address
Enter the IPX address that receives traps. Select On to enable trap
receiving.
Selected Errors
Select the events which will cause a trap to be generated from Add Paper,
Low Toner, Add Toner, Cover Open, Paper Jam, and All Other Errors.
Advanced > Management > SNMP > SNMPv3
The section below provides a summary of the items displayed on the SNMPv3
page. After you have changed the setting, you must restart the printing system.
SNMPv3
Sets whether to use the SNMPv3 protocol. Set On to use it.
Authentication
Sets whether to authenticate the user in SNMP communication.
Hash
Selects the hash algorithm. This item is displayed when the Authentication
is On.
Privacy
Sets whether to encrypt the communicated data in SNMP communication.
This becomes available when Authentication is enabled.
Encryption
Selects the encryption algorithm. This item is displayed when Privacy is On.
User Name
Enter the name of the read-only user.
Password
Enter the password for the read-only user.
User Name
Enter the name of the read/write user.
Password
Enter the password the read/write user.
Advanced > Management > LDAP > General
The printing system can refer to the address book which is on the LDAP server
as an external address book and assign a FAX number and E-mail address to
the destination.
LDAP
Enables or disables access to the LDAP protocol.
LDAP Server Name
Specifies a name or IP address for the LDAP server.
User Guide
6-40
To Next Page
Loading...
