Settings Pages
button to the left of a domain name which you want to make the default
domain.
Note: The default domain should be the one which belongs to the host
specified in Host Name.
Keyboard Login
This determines whether login authentication is allowed via the machine
operation panel or not, despite the IC card authentication is activated (using
the IC card authentication kit installed).
Advanced > Management > Authentication > Network User
Property
This allows to obtain user information at authenticating the user over the
network. The LDAP protocol must be enabled in order to obtain user
information.
Obtain Network User Property
Turned On to obtain user information.
LDAP Server Name
Specifies a host name or IP address for the LDAP server.
LDAP Port Number
Specifies a port number for LDAP or use the LDAP default port 389.
Search Timeout
Specifies a period of time for searching the LDAP server.
LDAP Security
Selects the type of encryption according to the type of security employed by
the LDAP server. Select Off when encryption is not used.
Authentication Type
Selects either the Simple or SASL for the authentication type.
Name 1 (2)
Specifies the LDAP attribute to obtain a user name for display, from the
LDAP server. The default for Name 1 is displayName.
E-mail Address
Specifies the LDAP attribute to obtain an E-mail address from the LDAP
server. The default is mail.
Advanced > Management > Authentication > Group Authorization
Set.
Once the network authentication has been established, you can add a group to
specify the Group Information and items for Job Authorization Settings.
LDAP must be enabled in order to activate group authorization.
Up to 20 group accounts are registerable. By default, a group account (Other)
has been preset. This is used to process any group account which does not fall
within the registered groups.
Group Authorization
Turned On if you want to individually authorize or deauthorize the groups.
Number of Registered Groups
COMMAND CENTER RX
6-43
To Next Page
Loading...
