Settings Pages
Set the number of job logs for sending, from 1 to 1500.
Run once now
You can test this by clicking the Send button to immediately send a report.
Advanced > Security > Secure Protocols
You can encrypt communication between a PC and this machine using SSL
encryption. For the changes made in the following to take effect, restart the
machine as described in Basic > Defaults > Reset on page 6-6.
SSL
Specifies whether or not to use the SSL protocol.
Serverside Settings
ā¢ Effective Encryption
Selects the encryption algorithm(s) to be used from DES, 3DES, and AES.
ā¢ HTTP Security
Specifies the security level.
ā¢ Secure Only (HTTPS)
Encrypts all HTTP protocol communication. Access is possible only with a
URL that begins with "https://." Access attempts using an ordinary http://
URL are automatically redirected to the URL where "http://" is replaced
with "https://."
ā¢ Not Secure (HTTPS & HTTP)
Enables access for both encrypted and unencrypted HTTP protocol
communication. Access is possible with https:// and http:// URLs. The
former URL establishes encrypted communication and the latter
establishes normal communication.
IPP Security
Specifies the security level.
ā¢ Secure Only (IPPS)
Encrypts all IPP protocol communications.
ā¢ Not Secure (IPPS & IPP)
Enables access for both encrypted and unencrypted IPP protocol
communications.
Clientside Settings
ā¢ Effective Encryption
Selects the encryption algorithm(s) to be used from DES, 3DES, and AES.
ā¢ Certificate Verification
When set On, verify the expiration of the server certificate at communication.
If found expired, communication will fail. When set Off, the expiration will not
be verified.
Note: When the SSL is set to On and HTTP Security is set to Secure
(HTTPS), the document boxes cannot be accessed by the TWAIN driver.
User Guide
6-46
To Next Page
Loading...
