Kyocera TASKalfa 8000i - Advanced > Protocols > Netware

Settings Pages
Start of Job String
Specifies the character string sent to the printer before output, directly to the
output port (lp port). This character string is used when it is necessary to
transmit a control code before the print data is sent.
End of Job String
Specifies the character string sent to the printer after output, directly to the
output port (lp port). This character string is used when it is necessary to
transmit a control code after the print data is sent.
Advanced > Protocols > NetWare
This printing system supports both NDS and bindery printing in either print
server mode or remote printer mode.
NetWare setup requires installation of the following client software and login
with Administrator Privileges. If you are unsure, please contact your network
administrator.
With Novell Client, creation of the NetWare print objects with the AdminManager
NetWare Setup Wizard requires the NetWare Client from Novell. For NetWare
printing, you may use the NetWare Client from either Novell or Microsoft.
For Admin Privileges, network operations (creating queues etc.) require 'admin'
or 'supervisor' privileges (or equivalent). Certain portions of AdminManager may
be inoperable if you attempt those operations without sufficient privileges.
NetWare Protocol
Enables or disables the Network Protocol.
Bindery Mode
Enables or disables Bindery Mode.
Frame Type
Sets the Frame type. You can choose from Auto, 802.3, Ethernet-II, SNAP or
802.2.
File Server (Primary)
Enter the name of the primary File Server.
NDS Tree
Enter the name of the NDS Tree.
NDS Context
Enter the NDS Context.
Printer Server Mode
Enables or disables Print Server Mode.
Print Server Name
Enter the Print Server Name.
Queue Polling Interval
Enter the Queue Polling Interval in seconds.
Password (optional)
Enter the Password, if required. Login to NetWare will be sucessful only the
password set here matches the Printer Server password set within the
NetWare utilities.
Remote Print Mode
Enables or disable Remote Print Mode.
COMMAND CENTER RX
6-33