Settings Pages
Enter maximum E-mail size in Kilobytes. When the value is 0, the limitation
for E-mail size is disabled.
Cover Page
Specifies whether to print the body of E-mail in addition to the attached files.
When this item is set to On, the attached files and the body of E-mail are
printed. When no attached files exist, only the body of E-mail is printed.
When this item is set to Off, only the attached files are printed. When no
attached files exist, nothing is printed.
Advanced > Management > SNMP > SNMPv1/v2c
The SNMP protocol is used for providing and transferring management
information within the network environment. Should an error occur such as Add
Paper, the printing system automatically generates a trap, an error message
sent to predetermined trap recipients.
The community names are used like passwords.
SNMPv1/v2c
Sets whether to use the SNMPv1/v2c protocol. Set On to use it. After you
have changed the setting, you must restart the printing system.
Read Community
Enter the community name for SNMP requests to read a value. The default
name is 'public'. After you have changed the setting, you must restart the
printing system.
Write Community
Enter the community name for SNMP requests to write (change) a value.
The default name is 'public'. After you have changed the setting, you must
restart the printing system.
sysContact
The MIB-II sysContact object. Usually this is the E-mail address of the
network administrator.
sysName
The MIB-II sysName object. Usually this is the host or domain name of the
printing system.
sysLocation
The MIB-II sysLocation object. Usually this is the location information of the
printing system.
HP Web Jetadmin Compatibility
Turns HP Web Jetadmin Compatibility On or Off. After you have changed
the setting, you must restart the printing system.
Authentication Traps
Specifies whether to use authentication traps. If enabled (On), an SNMP trap
is generated when an attempt to read or write is made using an incorrect
community name. The trap is sent to the configured trap address. After you
have changed the setting, you must restart the printing system.
Trap Community
The SNMP trap community name to be used when the printing system
generates a trap.
Trap IP Address (IPv4)
COMMAND CENTER RX
6-39
To Next Page
Loading...
