2. Features
KEW6024PV can measure insulation resistances of PV systems with open
voltages of 1000 V or less and of low-voltage installations with voltages of
600 V or less; moreover, earth resistance and AC/ DC voltage of distribution
lines and electrical appliances.
● Designed to meet the following safety standards.
IEC 61010-1,-2-030 CAT III 600V/ CAT IV 300V Pollution degree 2
IEC 61010-031
IEC 61557-1, -2, -5, -10
● Designed, produced and tested according to IEC60529 (IP54)
● Compact and light weight
● Backlight facilitating working in dimly lit areas
* The light automatically turns off if any button isn’t pressed for two minutes.
● The instrument automatically turns off if any button isn’t pressed for 10
minutes. This feature is disabled during a continuous measurement.
● Test probe with a remote control switch is supplied as standard accessory.
● Soft case – instrument is accessible while in use
● Strap belt allowing both hands free
● Replaceable metal tips are supplied as standard accessories
● Audible and visible live circuit warning
● Internal memory can store up to 1000 results. Data transfer and analysis to/
on a PC is possible by using the special software.
● Automatic AC/ DC detection at voltage measurement
To Next Page
Loading...
Need help?
General
