15. Battery replacement
When the battery indicator shows empty “ ”, replace the batteries with
new ones.
DANGER
● Do not open the battery compartment cover if the instrument is wet.
● Never attempt to replace batteries during a measurement. In order to
avoid getting electrical shock, ensure that the instrument is powered off
and test leads are disconnected from the instrument before replacing
batteries.
● The battery compartment cover must be closed and screwed before
starting a measurement. Otherwise, electrical shock hazard may be
caused.
CAUTION
● Do not mix new and old batteries or mix different types of batteries.
● Install batteries in correct polarity as marked inside.
(1) Power off the instrument, and then disconnect the test leads.
(2) Loosen two screws which are fixing the battery compartment cover, and
remove the cover.
(3) Replace all six batteries with new ones at the same time. Be sure that the
battery polarity is correct.
Use of six size AA alkaline batteries (LR6) is recommended.
(4) Install the battery compartment cover, and tighten two screws for the cover.
Fig. 15-1
w ww . .com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
