La Pavoni GRAN CAFFE - Preparing Espresso Coffee; Starting the Appliance; Use

23
EN
13. Pressurized lter holder*
14. Filter - 1 cup / pod*
15. Filter - 2 cups*
16. Coee tamper*
17. Automatic Cappuccino maker*
18. Insert for pods
19. Coee scoop
*Standard only on some models
4. USE
4–1. STARTING THE APPLIANCE
• Open the cover and ll the tank (1)
with fresh clean water, taking care not
to exceed the maximum level of the
tank.
• Turn on the machine by placing the
on / o switch (9) to position "I". The
lamp (9a) lights up to indicate that the
machine is powered.
• Insert the lter holder into the group
head.
• Open the steam / hot water knob (4).
• Move the coee / hot water switch
lever (10) to position “I”. When water
starts to come out of the turbo steam
nozzle (6), move the hot water / coee
dispensing switch lever (10) to position
“0” and close the knob (4).
After having done this, rinse the internal
circuits:
• Insert the lter holder (12-13) into the
group head (5).
• Place a container under the coee
dispensing spouts and press the coee
/ hot water dispensing button (10).
• Repeat this process 5 times.
• After rinsing, wait for the machine to
reach operating temperature. The light
(10a) comes on to indicate that the
temperature has been reached.
• After having done this, rinse the
internal circuits:
To avoid having to repeat this
procedure, we recommend that
you check the level of water in
the tank (1) to prevent emptying
the machine's water circuit. If this
does happen, repeat the above
procedure.
Take care not to pour water onto
the connector when lling the
tank.
The operating temperature light
(11a) will continue to switch on
and o automatically during
heating.
After having switched on the machine,
wait about 6 minutes for it to heat up
before making the rst coee.
4–2. PREPARING ESPRESSO COFFEE
Make sure that you have carried out all
the operations indicated in section 4.1
“starting the appliance”.
PRE-HEATING
• Make sure there is enough water in
the tank (1).
• Insert the lter holder (12) into the
group head, without a lter.
• Turn on the main switch (9), the power
on light (9a) will come on to indicate
that the machine is in operation.
• Wait until machine reaches the
operating temperature in order
to dispense a coee. The light
(10a) comes on to conrm that the
temperature has been reached.
PREPARING ESPRESSO COFFEE USING A
STANDARD FILTER HOLDER
• After pre-heating, remove the lter
holder (12), select the 1-cup lter (14)
if you wish to make one coee or the
2-cup lter (15) if you wish to make
two coees and place it into the lter
holder.