14
Drain Requirements
The drain hose, with a 0.57" (1.45 cm) ID is installed during manufacture. The drain
hose provides a flexible coupling to the building drain piping and can be secured with a
spring or band hose clamp. A band hose clamp is provided with the washer.
Tubing or pipe, 5/8" (1.6 cm) ID or larger, should be provided for the building drain. The
use of an air gap is strongly recommended to prevent siphoning of wastewater into the
washer.
Do not reduce the size of the drain plumbing.
Glassware Washers that have been converted to Mobile models drain into a sink
through a hose assembly that attaches to the faucet.
To Next Page
Loading...
Need help?
General
