57
Alerts
If a valid network connection has been established via the Ethernet accessory cable,
and Network settings have been properly configured, (via the Network screen) alerts
can be emailed to selected users, by entering the appropriate email address(es) and
selecting the type of alerts to be sent to each email address. To enable e-mail alerts
follow these instructions, and reference Fig. 6-19.
1. Each washer requires its own email address. Before proceeding, set up an
email address for each washer. The e-mail account can be any free service (i.e.
gmail.com, hotmail.com, etc) or a company’s hosted domain (i.e. xyzlabs.com).
2. Once the e-mail account(s) are set up, obtain the following information for each
account (e-mail address):
o SMTP Server
o SMTP Username
o SMTP Password
o SMTP Port Number
o Encrypted Connection
Here is an example (this information will not be correct for your e-mail
account) set-up for fake e-mail account: Wash123@gmail.com
o smtp.gmail.com
o Wash123
o cat@ndmouse457
o 465
o Enable
3. From the Alerts Screen, touch the Settings icon. A pop-up will display. After
entering the appropriate information in all fields, touch [Save]. The system will
check valid formatting only. If one or more invalid entries are found the following
message will appear: Email Settings Error. Correct the error and retry.
4. If all the SMTP fields entered are valid, but the network connection is not
working (or Ethernet cable is not connected) the following message will appear:
Email Settings Error – Network connection is not active. Resolve the
connectivity problem and retry.
To add a user’s email to receive e-mail alerts from the washer:
o Press the Add icon at the lower right corner to add an email address.
o Enter your e-mail address, touch [Done].
To test the user’s email:
o Touch
[Test] next to the desired e-mail address.
o If all information is correctly entered, a test email from the washer will
be sent.
To Next Page
Loading...
Need help?
General
