45
Edit a Program
From the Program Screen touch the program you wish to edit; the line will be
highlighted. If this is the correct program, press [Edit] (only allowed on an unlocked
program). The program parameters will be displayed. See Fig. 6-7.
To add a segment to the program, touch the Add Segment icon. A pop-up will display
segments that can be added. Based on the washer model and/or accessories installed,
a limited number of specific segments are allowed (limitations are found in Fig. 6-5).
Segments added will automatically be ordered correctly, for example a new Rinse
segment will be placed after the final Wash segment or if one or more Rinse segments
already exist, will be placed after the final Rinse segment. After selecting the segment
to add, the Segment Wizard will prompt you to enter each required parameter.
To delete a segment from the program, touch the segment, then touch the Delete icon.
To modify a segment parameter, such as temperature, time, or detergent/rinse-aid
dispense, touch the parameter value. A pop-up will appear, which allows the parameter
to be adjusted within allowable limits. Allowable limits are found in Fig. 6-5. After
making the desired change, touch [OK].
To lock or unlock a user program, touch the Lock icon. Locking a program prevents
modification/deletion when security is enabled for Programs.
After all changes are made, touch [Save]. If [Back] is touched before saving the
changes, you will be prompted that there are unsaved changes. To exit the program
edit screen without saving the changes, touch [OK].
Figure 6-7
Delete
Add Se
ment
Lock
To Next Page
Loading...
Need help?
General
