33
Level the washer side-to-side by placing a short level on the inside top edge of
the door. See the Fig. 4-8 for the placement of the level.
Check the level front to back by placing a level on the lower rack rails.
When the washer is level, check the operation of the washer door for alignment
with the washer tank.
Verify the door is centered in the opening by closing it slowly. If the door hits the
right side of the tank, raise the right front corner of the washer. If the door hits the
left side of the tank, raise the left front corner of the washer.
The racks can now be reinstalled.
Securing the Washer to the Countertop
If an undercounter washer model, two screws are provided to attach the front of
the washer to the underside of the countertop or work surface. After the washer is
level, in its final position and the washer door is properly centered, install the two
screws through the mounting tabs at the top of the tank, then into the bottom of
the counter top to stabilize the unit as shown in the Fig. 4-8.
Once the washer is in a secure position the toe kick panels can be reinstalled as
well as the lower filler panel if required to hide the space below the washers base.
Testing Your Washer
Now that you have made the required water and electrical connections to your washer,
a series of diagnostic steps are provided in this section to test the operation of the
washer.
Before turning on the washer, make certain the supply water is turned on and no
packing material remains inside the washer.
The electrical service to the washer can now be turned on.
Running Diagnostics
To verify the washer is operating properly, perform the diagnostics procedure detailed
below. This should take approximately 10 minutes to complete. Refer to Fig. 4-9 to
familiarize yourself with the control panel before you begin this procedure.
From any screen touch the HELP Icon.
Touch the Diagnostic icon.
Scroll down to Manual/Auto Run Test, select each component and confirm.
To Next Page
Loading...
Need help?
General
