Labconco FlaskScrubber 4121010 Series User Manual

97
Defective fill sensor
Check Sensor
Screen: >125mm
when full.
Pass: Recalibrate or
replace sensor.
Contact Labconco
Product Service.
Low Temp LT
Heater failure. Heater/s Test:
Fail: If heaters are
getting power and
wires have
conductivity, replace
heater/s
Check resistance
of heater for open
circuit
If open replace
heater.
Defective controller.
Check output from
IOB to heater.
Fail; Replace IOB.
Contact Labconco
Product Service.
Defective
temperature probe.
Check electrical
connections.
Repair connections
Defective high
temperature cut out
T-Stat.
Check resistance
of safety cut out
T-Stat.
If open circuit at
room temperature,
replace T-Stat.
No Water NW
Leak during wash or
rinse segment.
Check for leaks
both under and
around washer.
Fix Leaks.
Drain Valve failure
during wash or rinse
segment.
Check for draining
during wash
segment.
Replace drain valve.
Over Flow OV
Water in base.
Check for leaks
under wash tank.
Repair leaks under
wash tank or inlet
valves
Program Canceled PC
Program canceled
by operator or Fatal
Alarm.
No action
required.
No action required if
manually canceled.
Determine cause if
by another Fatal
Alarm.
Power Fail PF
Power Outage.
No action
required.
Program will resume
at the beginning of
interrupted segment.
Program Pause.
PP
Door opened or
program paused by
operator.
No action
required.
Restarting program
will resume where
paused.
Low Rinse Aid Cup RA
Rinse Aid in door low
Refill Rinse Aid in
door or dismiss
alarm.
Rinse Aid Cup not
used.
Turn Rinse Aid Cup
dispense off in
Accessories.

Labconco FlaskScrubber 4121010 Series Specifications

General

Brand	Labconco
Model	FlaskScrubber 4121010 Series
Category	Dishwasher
Language	English