EasyManua.ls Logo

Lagoon 620 - 9.1 Laying Up Procedures

Lagoon 620
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9.1 Laying up
Take ashore all the ship's log, the ropes that are not used for mooring,
the galley equipment, supplies, clothes, the safety equipment,
domestic batteries, the gas cylinders.
Check the expiry dates of the safety equipment.
Have the liferaft overhauled.
Take advantage of this laying up to draw up a complete inventory of
the equipment.
9.2 Protection
z
INSIDE
Drain all the fresh water pipes and rinse them (do not use a chlorine
based product).
Lubricate and close all the water inlet valves and sea cock fittings.
Rinse and completely drain the heads bowls and pumps.
Retract the sounder and speedometer sensors.
Seal air inlets as much as you can.
Install an air dehumidifier in the saloon and leave the cabin and
storage unit doors open (lockers, ice boxes).
Leave the cushions outside for long before putting them back into the
boat in the upright and side position in order to have minimum contact
surfaces.
z
OUTSIDE
Thoroughly rinse the hull and deck.
Lubricate all the mechanical and mobile parts with vaseline (bolts,
hinges, locks, etc.).
Protect all ropes and mooring lines against chafing.
Protect the boat to the highest degree with fenders.
Make sure the boat is properly moored.
z
ENGINES
The engines winterization shall be carried out by a professional.
Depending on the boat location, afloat or ashore, winterization is
different.
WINTER STORAGE / HANDLING
WINTER STORAGE
HANDLING
9
LAGOON 62O
107
RECOMMENDATION
All these recommendations do not make up an
exhaustive list. Your dealer will give you the advice
you need and will carry out the technical
maintenance of your boat.

Table of Contents

Other manuals for Lagoon 620

Related product manuals