5.3 Fresh water
z
TANKS
Each hull has a pressure water pump and two tanks linked together,
but independent between the port and starboard hulls.
To prevent any handling mistake, never fill the water and fuel tanks at
the same time.
During filling, avoid handling contaminants near the fillers.
Open and close the filler caps with the suitable key.
Check the filler cap seals for condition during filling.
The tanks are fitted with overflow outlets and vents.
Never insert the water filling hose deep down into the system in order
to prevent any over-pressure in the systems.
The tanks are fitted with inspection hatches therefore it is possible to
clean the inside.
Nota : the capacity of the fresh water tank(s) indicated on the page
'SPECIFICATIONS' may be not completely usable depending on the
trim and load of the boat.
z
SYSTEM
The pressure water pumps get to work via their breakers on the
electrical panel.
In case of failure of the pressure water pump, set its breaker to OFF
and open the transfer valve situated in the starboard engine bilge so
that the tank and working pressure water pump can take over.
z
WATER GAUGE
Check the gauges via the multifunction touch screen.
z
SHORE FRESH WATER SUPPLY
The shore fresh water supply is located in the port aft transom
extension.
To use the marina fresh water :
- Connect the shore supply.
- Set the breakers of the pressure water pumps to OFF.
- Open the shore supply valve (access by port engine bilge).
- Open the transfer valve (access by starboard engine bilge).
z
WATER-HEATER
Each water heater (one per hull) has a capacity of 60 litres.
The water heaters automatically work once their respective engines
are running, or on 220 V supply after the shore power supply is
plugged or after the generator started.
PLUMBING
PLUMBING
5
LAGOON 62O
75
RECOMMENDATION
- Pay attention to the quality of the water for the
filling up.
- Check if it is drinking water.
- If the boat is not used for long, purify the tanks and
pipes with proper treatment.
RECOMMENDATION
- Never operate water system equipment when the
valves are closed or when the tanks are empty (the
electrical equipment may be damaged).
- Check the different water filters for condition.
To Next Page
Loading...
