Laguna Tools SmartShop Maker - Auto Mode

SmartShop|Maker Owner’s Manual
32
2. Turn the handwheel in the counterclockwise (CCW) direction, the machine will move in the
negative direction. The speed is determined by the selected speed value.
6.12 Auto Mode
The operator can process a job under this mode. The machine will automatically run the NC
program.
1. Select the program file to process.
2. Set the job origin and tool length offset value, then press then press Auto Mode button. This
mode is only available after all axes have been homed.
3. Press the Auto Mode button and the system will begin the process of the selected file.
CAUTION
All axes must be homed after the power is on.
As the tool setting and job coordinate setting must be done based on the mechanical reference
point, after the CNC is switched on, reference point must be confirmed with all axes going back
Home.
1. Release the emergency switch. The system will display “READY”.
2. Click HOME.
3. Click Cycle Start.
NOTE
Home Z-Axis before other X, Y Axis to avoid interference.
NOTE
The direction can be set in the CNC parameters.