Laguna Tools SmartShop Maker - Part Program Selection

SmartShop|Maker Owner’s Manual
33
NOTE
The homing function homes all three (3) axes together.
NOTE
After homing, the mechanical coordinates are all “0”.
NOTE
The software limit switches of the machine are not enabled
until all axes are reset.
Do not engage the machine in movement too fast until the axes are reset.
1. Select F2 Program
2. Select F1 Operator Panel.
3. Select Program, select F2 Program.
4. Then select F3 File Manager.
6.13 Part Program Selection
Select the processing file, to F1 Execute.
1. Select File for Execution.
2. Select F2 Copy File for Execution.
3. Select F1 File Import for Execution.
4. Select F1 Copy File for Execution.
5. Select F1 Execute – To Execute File.