SmartShop|Maker Owner’s Manual
34
6.14 Job Origin Preset
1. Click on the F3 Offset/Setting softkey on the bottom menu of the main interface.
2. Use G54 as the 0 Point of Processing.
3. Press the Handwheel mode to control and move the X/Y/Z axis to material processing
surface, (for irregular materials, users need to set a center, and the workpiece origin should
be benchmarked on the zero (0) surface on which the tool is aligned with the workpiece).
4. ENTER – When the yellow cursor has been moved to X, press F1 on the panel (Latch
Machine cord). Choose Yes and press Enter on the panel.
5. Set Workpiece – choose F5 Set Workpiece.
6. Spindle tool length measurement using auto tool sensor.
7. Press the AutoTool button to enter the tool number to be measured in MDI mode.
8. Click F1 OK and the machine will automatically measure the tool length.
After the measurement is completed, the machine will automatically enter the tool length into
the system.
9. Click F3 Offset/Settings.
10. Click F2 Tool Set.
To Next Page
Loading...
