SmartShop|Maker Owner’s Manual
4
5.6 Switching Out the Tooling 22
5.7 Vacuum Table and Spoil Boards 23
5.8 Spoil Board Preparation 24
6.0 OPERATION 25
6.1 Power On 25
6.2 Main Interface 25
6.3 Homing the Machine 26
6.4 Tool Touch Off (TTO) Setup Procedures 26
6.5 External Shift 28
6.6 Processing Speed Adjustment 29
6.7 Idle Speed Adjustment 29
6.8 Power Off 29
6.9 Emergency Stop 30
6.10 Methods 30
6.11 Multiple Pulse Generator (MPG) Handwheel 31
6.12 Auto Mode 32
6.13 Part Program Selection 33
6.14 Job Origin Preset 34
7.0 RUNNING A PROGRAM 35
7.1 Transferring a Program from a Flash Drive 35
7.2 Running the Program 36
7.3 Running a Flycut Project 36
8.0 MAINTENANCE AND TROUBLESHOOTING 39
8.1 Cleaning the Helical Racks 39
8.2 Cleaning the Spindle Tray 39
8.3 Lubrication 39
To Next Page
Loading...
