Laguna Tools SmartShop Maker - Page 59

SmartShop|Maker Owner’s Manual
59
Error Code Potential Issue(s) Resolution(s)
Macro call too deep Programming error
Check machining program to
ensure that G65 calls MACRO
subprogram that has less than
twelve (12) layers.
Modal macro call too deep Programming error
Check machining program to
ensure that G66 calls MACRO
subprogram that has less than
four (4) layers.
Subprogram call too deep Programming error
Check machining program to
ensure that M98 calls
subprogram that has less than
sixteen (16) layers.
Too many modal macro
canel, G67
Programming error
Check program to ensure that
G66 and G67 are used in pairs.
G65,G66 must be the last
one in G code list
Programming error
Please check the machining
program.
Absent program number Programming error
Please check the machining
program to ensure the use of
G65 and G66.
Too many M code Programming error
Please check the machining
program to ensure that there are
equal or less than 3 M codes in
a single block.
Illegal variable access Programming error
Label not found Programming error
Please check the machining
program.
Line number not found Programming error
Enter the correct MDI line
number.