6. Press to exit to a previous menu or
make another menu selection or
press OFF to turn the meter off.
AVERAGING
The averaging option is available for color and turbidity testing. It allows the user to
average multiple readings. This option will improve the accuracy of samples with
readings that may tend to drift with time. When the two, five or ten reading options
have been selected, the meter will show a running average of the readings that have
been taken until the final average is displayed. The default setting is disabled. To
change the setting:
1. Press ON to turn the meter on.
1.3
2. Scroll down and then press *IOK
to select Options.
Main Menu
Measure
Date
* Options
16:02:19 01/04/05
3. Press *IOK to select Avera ging. Options
* Averaging
Turbidity
Chlorine
Date/Time
16:02:19 01/04/05
4. Scroll down and then press *IOK to
select an averaging option.
Available options are:
Disabled, 2 Measurements,
5 Measurements,
10 Measurements.
Note: The
*
is displayed next to the
current setting.
Averaging
Disabled
* 2 Measurements
5 Measurements
10 Measurements
16:02:19 01/04/05
30 OPTIONS & SETUP • A VERA G ING
To Next Page
Loading...
Need help?
General
