Lantronix UDS2100 - Table 11-2. Command Response Codes

11: Monitor Mode
UDS2100 Device Server User Guide 71
Command
Command Name
Function
8 = number of host bits
192.168.0.1 = gateway IP address
10001 = port number of the UDS
192.168.1.10 = IP address of the DNS Server
The UDS stores the setup and performs a reset. It
sends an X before the reset if the command was
OK.
VN
Query full firmware
version
This command queries and displays full firmware
version in readable string format.
Note: Entering any of the commands listed above generates one of the
following command response codes:
Table 11-2. Command Response Codes
Response
Meaning
0>
OK; no error
1>
No answer from remote device
2>
Cannot reach remote device or no answer
8>
Wrong parameter(s)
9>
Invalid command